qmk_firmware/keyboards/adafruit/macropad
2023-08-23 01:00:03 +01:00
..
keymaps [Keymap] Drashna Keymap updates for 0.21.0 (#21073) 2023-05-31 11:44:06 -07:00
config.h Move RGBLED_NUM to data driven (#21278) 2023-06-18 14:39:07 +10:00
halconf.h
info.json RGB Matrix: driver naming cleanups (#21594) 2023-08-23 01:00:03 +01:00
macropad.c
mcuconf.h
readme.md
rules.mk OLED Driver improvements (#20331) 2023-05-10 14:04:53 -07:00

Adafruit MacroPad RP2040

AdafruitMacropad

A RP2040-powered Macropad with a 3x4 layout.

Make example for this board (after setting up your build environment):

qmk compile -kb adafruit/macropad -km default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Features

  • Raspberry Pi RP2040 Chip + 8MB Flash memory - Dual-core Cortex M0+ at ~130MHz with 264KB of RAM.
  • 3x4 Mechanical key switch sockets - accepts any Cherry MX-compatible switches. Individually tied to GPIO pins (not matrix wired)
  • One NeoPixel RGB LED per switch, on north side.
  • Rotary encoder, 20 detents per rotation, with push-switch on GPIO pin. Push switch is also used for entering bootloader mode when held down on power-up or reset.
  • 128x64 SH1106 Monochrome OLED display - On high-speed hardware SPI port for quick updates.
  • 8mm Speaker/Buzzer - With Class D amplifier and RC filter, can be used to make simple beeps and sounds effects. (Unsupported for now)
  • STEMMA QT Connector - Allows adding any I2C sensors/displays/devices with plug-and-play cables.
  • Reset button - On the side, for quick restarting, press it twice to enter bootloader.
  • Four M3 mounting bosses - Make custom enclosures easily.

Bootloader

Enter the bootloader in 4 ways:

  • Bootmagic reset: Hold down the key just below the rotary encoder push-button on power-up.
  • Physical reset button: Press twice the button on the side while the board is connected.
  • BOOT button Hold down the rotary encoder push-button on power-up or reset.
  • Keycode in layout: Press the key mapped to QK_BOOT if it is available.