qmk_firmware/keyboards/cradio
Albert Y b8951a0458
Add LAYOUTS entry to rules.mk (#15900)
* Add layouts to rules.mk

* Remove excess settings.

Co-authored-by: Joel Challis <git@zvecr.com>

Co-authored-by: Joel Challis <git@zvecr.com>
2022-01-17 14:11:58 +00:00
..
keymaps/default [Keyboard] Switch a_dux, cradio and ferris to split_3x5_2 (#15850) 2022-01-13 09:15:01 -08:00
config.h
cradio.c
cradio.h Add LAYOUTS entry to rules.mk (#15900) 2022-01-17 14:11:58 +00:00
info.json [Keyboard] Switch a_dux, cradio and ferris to split_3x5_2 (#15850) 2022-01-13 09:15:01 -08:00
readme.md
rules.mk Add LAYOUTS entry to rules.mk (#15900) 2022-01-17 14:11:58 +00:00

Cradio keyboards

Cradio

Cradio are minimalist 34-key split-keyboards designed with no diodes, using direct micro-controller pin wiring.

Keyboard Info

  • Keyboard Maintainer: David Barr
  • Hardware Supported:
  • Hardware Availability: order PCBs using gerber files from the repository

Make example for this keyboard (after setting up your build environment):

make cradio:default

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Setting Handedness

Firmware uses handedness by EEPROM as default and it must be configured once on each side. The make commands are:

make cradio:default:dfu-split-left
make cradio:default:dfu-split-right

QMK Toolbox can also be used to set EEPROM handedness. Place the controller in bootloader mode and select menu option Tools -> EEPROM -> Set Left/Right Hand

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset: Hold down the top left key on the left half (or the top right right key on the right half) and plug in the controller on that side.
  • Physical reset button: Briefly press the reset button soldered on the PCB.
  • Keycode in layout: Press the key mapped to RESET if it is configured.

Swapped Pins

If you have one of the PCB variant with swapped letters Q and B / P and N, add the following code to your keymap's config.h to swap pins E6 and D7 in the firmware:

#undef DIRECT_PINS
#define DIRECT_PINS { \
    { D7, F7, F6, F5, F4 }, \
    { B1, B3, B2, B6, D3 }, \
    { D1, D0, D4, C6, E6 }, \
    { B4, B5, NO_PIN, NO_PIN, NO_PIN } \
}
#undef DIRECT_PINS_RIGHT
#define DIRECT_PINS_RIGHT { \
    { F4, F5, F6, F7, D7 }, \
    { D3, B6, B2, B3, B1 }, \
    { E6, C6, D4, D0, D1 }, \
    { B5, B4, NO_PIN, NO_PIN, NO_PIN } \
}