9dcd03b6ca
* Set bootloader to stm32-dfu for STM32F303 * Set bootloader to stm32-dfu for STM32F0x2 * Set bootloader to stm32-dfu for STM32F4x1 * Set bootloader to stm32duino for sowbug * Delete redundant bootloader_defs headers * Add some missing MCU name comments * Move APM32 dfu-suffix overrides underneath bootloader * Remove redundant STM32_BOOTLOADER_ADDRESS defines/rules |
||
|---|---|---|
| .. | ||
| hotswap | ||
| j02 | ||
| keymaps | ||
| rev2 | ||
| chconf.h | ||
| config.h | ||
| db60.c | ||
| db60.h | ||
| halconf.h | ||
| info.json | ||
| mcuconf.h | ||
| readme.md | ||
| rules.mk | ||
CannonKeys DB60
DB60 "Daughterboard 60" Keyboard
- Keyboard Maintainer: Andrew Kannan
- Hardware Supported: STM32F072CBT6 (or equivalent)
Make example for this keyboard (after setting up your build environment):
make cannonkeys/db60/rev2:default
See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.
Some notes about the versions: The original DB60 was shipped with the J-02. To build that, you will need to use the following command:
make cannonkeys/db60/j02:default
Solderable DB60s were shipped with keyboards after the J-02. This variant has cutouts along the top and bottom to support O-ring gasket mounting. To build these, you can use this command:
make cannonkeys/db60/rev2:default
Hotswap ANSI DB60s were shipped with the Bakeneko keyboards from CannonKeys. These also have the o-ring gasket mounting points. To build this:
make cannonkeys/db60/hotswap:default