qmk_firmware/keyboards/junco
2024-08-26 07:51:22 +10:00
..
keymaps/default Remove all via-enabled keymaps, including via. (#24322) 2024-08-26 07:51:22 +10:00
rev1 Migrate SERIAL_DRIVER to json (#23925) 2024-07-13 13:12:35 +01:00
readme.md
rules.mk Miscellaneous keyboard.json migrations (#23378) 2024-04-03 23:14:03 +01:00

Junco

Junco

Junco is a 60% Raspberry Pi Pico powered split keyboard boasting a 4x6 layout with an aggressive columnar stagger. It has 5 "thumb" keys on either side, support for 2-4 rotary encoders, and per-key RGB lighting.

Remember you have to flash both halves of the keyboard for it to work!

Make example for this keyboard (after setting up your build environment):

make junco:default

Flashing example for this keyboard:

# For flashing the left half...
make junco:default:uf2-split-left
# or the qmk cli equivalent:
qmk flash -kb junco --keymap default -bl uf2-split-left

# For flashing the right half...
make junco:default:uf2-split-right
# or the qmk cli equivalent:
qmk flash -kb junco --keymap default -bl uf2-split-right

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

  • Bootmagic reset (works after you have flashed once): Hold down the top far corner key while plugging in the keyboard (~ left half, - right half). This will also clear the EEPROM.
  • Physical reset button: Hold the BOOT button on the Pico and press the RST button on the Pico, release the the RST button before the BOOT button.
  • Keycode in layout: In the default layout, the Bootloader keycode is above home row pinky on the right side's adjust layer.

Once you enter the bootloader, the keyboard will show up as a USB device on your computer, you could drag and drop a firmware file to flash it, but I recommend using the flash commands for the respective side.